Move file (page)
If you are going to paste a page into
an existing character set, then you can use the command Move file (page) for
this purpose. This command enables you to move one or more pages and therefore
create or close a gap in the numbers. This operation is always
used on the character set (or in CPP mode, on the part-project) which belongs to the drawing window
currently open. You must enter a total of 3 page numbers during
the moving process. The range is determined by the last number
which you have entered. This last number may also be larger than the last
existing page number.
Hint
If a file is being overwritten,
a prompt will appear beforehand.
Example
Move file (page) :[Create
gap]
Your set of drawings includes the page
numbers (=number extension) from *.0001 to *.0020 and *.0040 to *.0060.
You want to create a gap for a new page *.0004. The previous page *.0004
should then receive the page number *.0005. The numbers from 40 onwards
should not be changed.
- Load Page *.0004
- Activate the Move file command
- Enter the following in the entry
field of the information bar on request:
|
Text type |
Value |
|
Start number: |
4 (gap for new page) |
|
End number: |
5 |
|
Last number:
(of the set of drawings with are to be
moved at the same time) |
20 |
Result:
Page 1, 2, 3, 5, 6, ....20, 21,
40 ... 60 => Page number 4 is missing.
Use the New file or Copy file
command in order to create a new Page *.004.
Move file (page): [close
gap]
Your set of drawings has the page numbers
(=number extension) from *.0001 to *.0020 and *.0040 to *.0060. You want
to close a gap (assuming that Page number *.0004 is missing). The
previous Page *.0005 should then receive the page number *.0004. The numbers
from 40 onwards should not be changed.
- Load Page *.0005
- Activate the Move file command
- Enter the following in the entry
field of the information bar on request:
|
Text type |
Value |
|
Start number: |
5 (gap for new page) |
|
End number: |
4 |
|
Last number:
(of the set of drawings with are to be
moved at the same time) |
20 |
Result:
Page 1, 2, 3, 4, 5, 6, .…19,
40 ... 60 => Page number 20 is missing.
Use the New file or Copy file
command in order to create a new Page *.0020.
Hint
If the active working
window does not belong to the project, when using the Move file (page)
function, a message will appear to that effect. This prevents you from
accidentally accessing a project which you have only opened temporarily.
Numbering and cross-references are not automatically adjusted during this
operation. Then use the appropriate automatic functions.